Page 1 of 3
505 error
Posted: Fri Dec 23, 2022 11:49 am
by repauli1
Anyone else getting a 505 error "invalid value" error after loading a (newest version sheetcam, AND Centroid Acorn 8.2) a gcode file, and pressing GRAPH?
Will upload report when customer is available.
Thanks
Bob
Re: 505 error
Posted: Fri Dec 23, 2022 3:29 pm
by Joey
Haven't update the latest version of Sheetcam. Will check that out here shortly
Re: 505 error
Posted: Fri Dec 23, 2022 4:09 pm
by Joey
Just threw a couple dxf's into the latest SheetCam TNG V7.0.20. Everything worked as expected. Can you throw the Gcode file up so I can have a look at it.
Re: 505 error
Posted: Fri Dec 23, 2022 5:31 pm
by fisher_transport
joey you want to team view my system and check it out? i tried uploading file but the forum system wont except .tap or .job
Re: 505 error
Posted: Fri Dec 23, 2022 5:38 pm
by fisher_transport
file
Re: 505 error
Posted: Fri Dec 23, 2022 5:49 pm
by Joey
I'd like to check it out yes. I just tried the file on my machine and I'm able to run it.
Re: 505 error
Posted: Fri Dec 23, 2022 5:53 pm
by Joey
Send me an email or txt a picture of the Team Viewer info. You can call my cell when your ready. Email
mccullochjoey@gmail.com
Cell: 8145711043
Re: 505 error
Posted: Fri Dec 23, 2022 5:56 pm
by Joey
Have tried loading the .TXT file you posted? That's what I loaded. But I'm not sure the gcode is exactly right...
Re: 505 error
Posted: Fri Dec 23, 2022 8:19 pm
by fisher_transport
joey didnt want to txt you but this look better?
Re: 505 error
Posted: Fri Dec 23, 2022 8:34 pm
by Joey
Results were the gcode that Sheetcam was outputting had M codes from another system that could not be read. In the gcode file that was posted the lines that started with M67 were commented out because they were causing CNC12 to throw an error. M67 is not used or read by CNC12 and cannot be used.
Lesson from this is it's a good idea to remove any previous systems mcodes or setting when using Sheetcam for Acorn Plasma. Once the previous systems settings were removed Sheetcam posted clean Gcode that functioned properly with Acorn Plasma.