Configuration wizard Torch Touch Off Grayed out
Posted: Thu Sep 01, 2022 6:15 pm
Hello,
I am currently working on setting up my CNC plasma table with a Hypertherm 45xp. I am using an existing acorn board and a custom 4x4 CNC table that has been previously working and operating with CNC12 mill pro. I am Currently converting the table to Acorn plasma
I have bench tested the THC kit and installed and wired the plasma cutter with the CPC cable.
Installed the conductive wire to the torch tip
When opening the wizard to select the torch touch off method as conductive. The slider button that says "is torch being used in conjunction with a float switch" Is grayed out and set to YES and will not allow me to set it to NO.
Im just trying to fire the torch for testing purposes, Do I need a paid version of CNC12 plasma?
Do you have to have an Estop circuit wired in to fire torch?
Thanks!
I am currently working on setting up my CNC plasma table with a Hypertherm 45xp. I am using an existing acorn board and a custom 4x4 CNC table that has been previously working and operating with CNC12 mill pro. I am Currently converting the table to Acorn plasma
I have bench tested the THC kit and installed and wired the plasma cutter with the CPC cable.
Installed the conductive wire to the torch tip
When opening the wizard to select the torch touch off method as conductive. The slider button that says "is torch being used in conjunction with a float switch" Is grayed out and set to YES and will not allow me to set it to NO.
Im just trying to fire the torch for testing purposes, Do I need a paid version of CNC12 plasma?
Do you have to have an Estop circuit wired in to fire torch?
Thanks!