let me know if you have any favorites to add to this page.
Re: New Build - CNC Plasma Table
Posted: Thu Jul 21, 2022 10:27 pm
by landmark573
Thanks Keith. Decided to forgo touch screen. I picked one up from Amazon.
Re: New Build - CNC Plasma Table
Posted: Thu Jul 21, 2022 10:32 pm
by landmark573
I see that Centroid is using Sheetcam and there is a post processor available that Keith posted. I haven't seen one for Fusion 360 though.
Re: New Build - CNC Plasma Table
Posted: Thu Jul 21, 2022 10:46 pm
by landmark573
Looks like a built a plotter. Checking turns ratio setting and gantry squareness. Looks pretty good as close as I can measure with a sharpie
Re: New Build - CNC Plasma Table
Posted: Fri Jul 22, 2022 11:31 am
by cnckeith
post a fresh report.zip so we can follow along.
Re: New Build - CNC Plasma Table
Posted: Fri Jul 22, 2022 6:11 pm
by landmark573
New report attached.
I'm trying to recalibrate Float Switch Z zero offset but when I trigger the float switch I get a 9101 Torch Breakaway error and have to cycle reset to clear the error. I don't have a Breakaway input defined.
Re: New Build - CNC Plasma Table
Posted: Fri Jul 22, 2022 9:50 pm
by landmark573
First cut video on YouTube
Re: New Build - CNC Plasma Table
Posted: Sat Jul 23, 2022 12:15 am
by ShawnM
The float switch also acts as a breakaway when NOT running a touch off cycle. This is outlined in the plasma manual.
In your video, did you cut the same line twice? It didn't even look like there was a pierce delay for your material.
Re: New Build - CNC Plasma Table
Posted: Sat Jul 23, 2022 10:01 am
by landmark573
I did read that in the manual and even made a note of it in my notes. It just didn't make the connection.
I did make a couple of failed cuts on the same line where the pilot arc started but never fired. Then I remembered the work clamp. I was using the Steel 45A .250 standard profile but don't remember what the pierce delay was set to. I will dig into it today.