Torch stops and Rises up
-
- Posts: 5
- Joined: Tue Apr 09, 2024 1:52 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Torch stops and Rises up
I run a CnC plasma but instade of firing the torch stops and Rises up. Could this be something that would be solved within the software..
-
- Posts: 521
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Torch stops and Rises up
Your Machine with Acorn Mill is Controlled by the Gcode completely.
If the Job stops without an error in the message LOG. it was most Likely something in the Gcode.
If there's a question of why a Job stopped. Attaching the Gcode Job with the post would Help A lot.