Hello
I have a few pieces to do a part off cut. all the same in the same place.
So I am doing it in the utility part off ...but since I need to repeat it I need to run it time and time again.
what would be a fast way to repeat the part off?
Tnx!
What would be the fastest way to repeat part off?
-
Rare
- Posts: 13
- Joined: Tue Dec 31, 2024 5:09 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
What would be the fastest way to repeat part off?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
tblough
- Posts: 3452
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: What would be the fastest way to repeat part off?
Use Intercon to make a quick program to do it.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)