Thats odd. Can you post a fresh report Please.
The Report will have all you settings and macros. So I can then really see what the control is doing and why.
Can you also Post the G-code used.
I'm thinking the M61 macro is at fault of there is something going on in the G-code.
Was the G-code job from the MM folder?
Please help! I fried my THC!!!
-
- Posts: 10
- Joined: Mon Jul 24, 2023 10:44 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Please help! I fried my THC!!!
Sorry, I should really have started a new post as this really would be a new topic. I'll run a report on the machine and then re post as a new topic if you prefer.