thc encoder error
-
jeffery.meacham
- Posts: 8
- Joined: Thu Nov 16, 2023 9:53 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
thc encoder error
we have cut several parts this morning with ease we are getting a 9105 encoder error both tx and rx boards are getting power fiberoptic cable appeares to be fine any ideas?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Joey
- Plasma/Laser Lead
- Posts: 642
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: thc encoder error
Can you attach a fresh report.
Is the encoder error intermittent?
A loose encoder cable could also cause an encoder error.
Is the encoder error intermittent?
A loose encoder cable could also cause an encoder error.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
jeffery.meacham
- Posts: 8
- Joined: Thu Nov 16, 2023 9:53 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: thc encoder error
attached is a current report any ideas would be helpful after trying different things i noticed when we disable thc machine will move again and operate normally yet no thc enable thc and 9105 encoder error prevents everything from moving
- Attachments
-
- report_3484E4263288-1013237522_2023-11-28_07-16-24.zip
- (3.4 MiB) Downloaded 72 times
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Joey
- Plasma/Laser Lead
- Posts: 642
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: thc encoder error
Looking through the Plots in the report I'm not seeing any voltages read in any plots.
Did you do a calibration cut?
Do you know the THC was ever working?
What Plasma cutter do you have?
Did you do a calibration cut?
Do you know the THC was ever working?
What Plasma cutter do you have?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)