Greetings,
Does anyone have any information on setting up a everlast 82i plasma cutter with the acorn thc board?
Best Regards,
Walter Hall
Acorn CNC Plasma/Everlast82i
-
- Posts: 528
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Acorn CNC Plasma/Everlast82i
BMF has a thread where he was trying tlan Everlast with the THC. The THC plots didn't look too bad just that I'm not sure if the calibration was able to use the voltage. Looked like THC did react to the spike at the end of the cut. Not sure if his target voltage was just not set right. He was going to post another report when he had more parts to make. His thread is here.
https://centroidcncforum.com/viewtopic. ... ast#p69748
I'll ask if he has cut anything else yet.
https://centroidcncforum.com/viewtopic. ... ast#p69748
I'll ask if he has cut anything else yet.