Hi, working through the bench test using the latest release of the manual and I have found an anomaly between the text and the illustration.
On the Drive Bus allocation section the text says to set parameters 300, 301 and 303 i.e. skipping parameter 302, however the figure 4.1.7 shows that 300,301 and 302 are set.
Which is correct.
Thanks,
Neil
Manual error?
Moderator: cnckeith
-
NeilS
- Posts: 11
- Joined: Sun Dec 24, 2023 12:54 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: Yes
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Manual error?
- Attachments
-
-
dpascucci_support
- Posts: 93
- Joined: Thu Sep 21, 2023 9:24 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: No
- CPU10 or CPU7: No
Re: Manual error?
You are correct, this is an error. It should read Parameter 302 = 3.
I will get that corrected soon.
I will get that corrected soon.
Domenic
When requesting support READ THIS POST first.
Please ALWAYS post a FRESH report.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
When requesting support READ THIS POST first.
Please ALWAYS post a FRESH report.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)