New Oak board old VFD old knee mill

[ballbearing00]

Does anyone have a good schematic for Delta VFD-E (VFD037E23A 5HP)
Need to know the proper connections to new Oak board
Any help would be greatly appreciated!

[ashesman]

I think its pretty well laid out in the Oak wiring examples. Look in the link below and search Delta. There is only a handful of wires to hook up, maybe eight. Even less if you are not using a motor encoder. I have an Oak and Delta VFD on my machine. I don't remember where my wiring diagram is for it but could probably dig it out if you get stuck.

https://www.centroidcnc.com/centroid_di ... browse.php

There is also a Delta C2000 setup guide in the section below. It wont be exactly the same for your VFD, but will help list out the things you will need to configure in your VFD.

https://www.centroidcnc.com/centroid_di ... browse.php