Cnc12 V5.06 loading a program

[suntravel]

Depends on the CAM. You can have a complete machine model to do simulations, detect possible crash...

Very handy for multiaxis mill turn machines.

Uwe

[Sword]

It sounds like you may be asking about the G-code preview when a file is loaded.

In the Wizard...Preferences/CNC Control, and set "Part G-Code Preview On Job Load" to "Yes".

[Houseman303]

wizard only for acorn acorn/6

[suntravel]

wizard only for acorn acorn/6

But manual is the same on all

Look at parameter 46

Uwe

[Houseman303]

Parameter 46 only for aktive Gcodes

[suntravel]

ok, then P#417=1

Uwe

[cnckeith]

post a fresh report.zip so we can see your configuration settings.

G code preview is a feature in CNC12 that is not on by default in some installations, to turn it on use P417 (part g code preview) as pointed out by Uwe (thanks)

other g code job related parameters are:

Display active g codes. P46
Run time graphics on by default P150 ( i set this to NO, as you can always go into the graphics mode at any point from the main screen)
Remember last g code job after restart P401

i'm moving this thread out of the beta forum since its not a beta discussion.