I am adding a function to my mill and would like to use the Aux9 output contactor, calling it up with an M Code in program (Both ON & OFF)?
Aux9 output is currently actuated by Aux3 Key.
This was used for a spindle brake pneumatic solenoid long before I acquired it (Don't need or use).
Not sure how to check and see if M Code function was set up?
Thanks
Aux Contact output mapping to M Code
Moderator: cnckeith
-
Moose
- Posts: 59
- Joined: Tue Apr 10, 2018 9:36 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Aux Contact output mapping to M Code
I did some research and found the YouTube videos of PLC programing.
I believe I have it figured out.
Thanks
I believe I have it figured out.
Thanks