Motor(s) Hot
Posted: Fri May 19, 2023 1:20 pm
Greetings,
Have Knee Mill with older control. Model M-10.
After morning start-up and boot-up I can move
all 3 axles in manual mode, but when I hit cycle
start to run a program I get no movement and
immediate message--- Motor(s) To Hot; Job cancelled.
Any ideals ?
Have Knee Mill with older control. Model M-10.
After morning start-up and boot-up I can move
all 3 axles in manual mode, but when I hit cycle
start to run a program I get no movement and
immediate message--- Motor(s) To Hot; Job cancelled.
Any ideals ?