umbrella atc
Moderator: cnckeith
-
- Posts: 5
- Joined: Wed Apr 29, 2015 1:45 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
umbrella atc
Im in the middle of trying to complete a retrofit on a 1991 haas vf1 with a umbrella style tool changer. I have the allinone and the plcad1616 I didnt recive any examples of wiring the ATC with the kit, was I suppose to? also I have a mitubishi a500 with the fra5ap card in it. I just need a little direction on getting this tool changer started, can i use the spindle plung pin for ATC spindle alignment or do I need to install a encoder on the spindle? thanks in advance for the help
-
- Posts: 433
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: umbrella atc
A full size schematic showing ATC hookups should have been included with your kit. Do you have your kit number (or otherwise please send me a private message with the name / company it was purchased under)? With that I can get you the right schematic.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)