1) I use the search feature for about everyting I ask. I usually find some ref. sometimes a fix. But usually no fix. Being in IT- I always update our archive threads w the fix. If you can tell me this fix , I'll go an update the thread in question on screen size for a DOS program.
2) In the CONFIG screen for Motor encoder turns and REV. the page is too small to show the REV setting. How do I set the screen size in a Win-7 batch program? Any help appreciated.
Thanks,
'CG
RESOLVED:How to reset Screen Size. Missing Rev on setups.
Moderator: cnckeith
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
RESOLVED:How to reset Screen Size. Missing Rev on setups.
Last edited by countryguy on Tue Mar 17, 2015 1:55 pm, edited 1 time in total.
Re: How to reset Screen Size. Missing Rev on Motor setups.
Control Panel -> Appearance and Personalization -> Display.
Choose "Smaller (100%)".
As for how you would set that from a command prompt or batch file, I have no idea. That would be a good question for a Microsoft-trained IT person.
Choose "Smaller (100%)".
As for how you would set that from a command prompt or batch file, I have no idea. That would be a good question for a Microsoft-trained IT person.
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: How to reset Screen Size. Missing Rev on Motor setups.
Thanks a TON!!