Programing radius on my mill
Moderator: cnckeith
-
- Posts: 1
- Joined: Tue Sep 27, 2022 2:14 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Programing radius on my mill
I got my mill up and runs great trying to program a end mill to do a radius need help.
-
- Posts: 3097
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Programing radius on my mill
Section 10.7.3 in the mill manual describes the four methods of cutting an arc in Intercon: End Point & Radius, Center Point & Angle, Center Point & End Point, and Mid Point & End Point. Start Point is always the end point of the previous move.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.