centroid m15-9

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
philroy5033
Posts: 23
Joined: Sat Feb 12, 2022 4:15 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

centroid m15-9

Post by philroy5033 »

Hello I have a Centroid m15-9 control panel with a problem.
Upon power up the EV backlight comes on but nothing else happens.
I looked at the power supply and all voltages are within spec.
It looks as though the main computer board is dead.
Does Centroid fix old units or is there a third party repair shop?
Any suggestions on trouble shooting would be accepted and helpful.

Your,
Phil;
cncsnw
Posts: 2794
Joined: Wed Mar 24, 2010 5:48 pm

Re: centroid m15-9

Post by cncsnw »

Ed Tremblay at East Coast EDM has been tackling repairs on these units recently.

https://eastcoastedmmachine.com/centroi ... repairs-2/
Post Reply