Hello I have a Centroid m15-9 control panel with a problem.
Upon power up the EV backlight comes on but nothing else happens.
I looked at the power supply and all voltages are within spec.
It looks as though the main computer board is dead.
Does Centroid fix old units or is there a third party repair shop?
Any suggestions on trouble shooting would be accepted and helpful.
Your,
Phil;
centroid m15-9
Moderator: cnckeith
-
- Posts: 23
- Joined: Sat Feb 12, 2022 4:15 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: centroid m15-9
Ed Tremblay at East Coast EDM has been tackling repairs on these units recently.
https://eastcoastedmmachine.com/centroi ... repairs-2/
https://eastcoastedmmachine.com/centroi ... repairs-2/