Quick dumb question on a linear scale.
Moderator: cnckeith
-
- Posts: 17
- Joined: Thu May 13, 2010 12:19 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: No
Quick dumb question on a linear scale.
I did a search for using a scale ase a 4 th axis dro on the quill of my mill. My scale only has 5 wires plus a shield. Scott said in a post tht it has to be a quadruature signal. Will my scale provide this and if so do I just use A+ A- B+ B- and the 5v wire? The Scale is an anilam RBM-5T.
-
- Posts: 86
- Joined: Sat Dec 27, 2014 4:53 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: Quick dumb question on a linear scale.
I did some googling and did not see if they are or not, but most were from what I know (which is not much) I can tell you the Magnetic scales are cheap, very reliable, rugged, and I plan on putting that onto Z and feeding into the open input (if I ever get my 3K encoder stuff sorted out). My 3cents. CG
-
- Posts: 7494
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Quick dumb question on a linear scale.
you'll need a scale that has differential quadrature output A A- B B- Z Z -
from the all in one DC install manual page 13.
fyi.. http://www.zsinstruments.com/ makes a nice scale and they will preconfigure the cable db9 connector to match ajax/centroid.. so its plug and play.
from the all in one DC install manual page 13.
fyi.. http://www.zsinstruments.com/ makes a nice scale and they will preconfigure the cable db9 connector to match ajax/centroid.. so its plug and play.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html