Hello everyone,
I'm having a problem homing my machine. I replaced the 2032 battery and when I tried to restart the machine I got this error message on the screen.
Thanks for any help.
Mitch
Centroid 3 axis control on Accu II knee mill
Moderator: cnckeith
Re: Centroid 3 axis control on Accu II knee mill
First guess would be a dead logic power supply (micro-ATX supply) on the back of the DC3IO unit in the cabinet.
PS: this should be in the "Oak, Allin1DC, MPU11 and Legacy products" forum, rather than the Acorn forum.
PS: this should be in the "Oak, Allin1DC, MPU11 and Legacy products" forum, rather than the Acorn forum.
-
- Posts: 6
- Joined: Sun Mar 08, 2020 5:01 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 125050511
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: Yes
Re: Centroid 3 axis control on Accu II knee mill
What is the DC310 unit? Thank you for correcting where I should be posted.
Re: Centroid 3 axis control on Accu II knee mill
"Dee see three eye oh"
It is in the control cabinet. It is your servo drive and PLC unit, assuming you have an M400S control with a serial number between roughly 20230 and 21190.
See http://www.cncsnw.com/Drives.htm#DC3IO
It is in the control cabinet. It is your servo drive and PLC unit, assuming you have an M400S control with a serial number between roughly 20230 and 21190.
See http://www.cncsnw.com/Drives.htm#DC3IO