I have a wireless MPG (Centroid model# CWP-4), and it frequently stops responding if left inactive for a while.
The only way I have found to fix the issue is to do a complete power cycle.
When the issue occurs, it still shows a good signal and shows that it is connected, however it is unresponsive. Battery gauge shows strong battery.
I have power saving turned off on the PC, in case it is a USB power-saving issue.
How can I make sure that it stays working all day?
Wireless MPG stops responding when sitting idle
Moderator: cnckeith
-
- Posts: 3
- Joined: Fri May 24, 2019 9:17 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: A900678
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
-
- Posts: 7164
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Wireless MPG stops responding when sitting idle
try a different USB port
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html