Work offset changing in the middle of a program
Moderator: cnckeith
-
kenlewis1965
- Posts: 1
- Joined: Fri Jun 24, 2022 11:19 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0008DC111213-0319211116
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Work offset changing in the middle of a program
Has anyone had the problem of your work offset (G54) randomly changing in the middle of the program.
-
tblough
- Posts: 3098
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Work offset changing in the middle of a program
Not without issuing a G52 command. Are you sure it's the same WCS and there is not a call to another WCS in your program?
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Re: Work offset changing in the middle of a program
A G92 would do that too.
Or, if you are talking about a lathe control, then a G50 with X, Z, U or W coordinates.
Post a copy of the CNC program here, along with a Report from your control.
Or, if you are talking about a lathe control, then a G50 with X, Z, U or W coordinates.
Post a copy of the CNC program here, along with a Report from your control.