I'm finally getting back on a project I started 3 years ago and am completing my wiring.
Somehow the E stop is set up for a NO switch. I have a good feeling I changed it 3 years ago and cannot figure out where to change it back.
OAK E stop - somehow setup for NO switch
Moderator: cnckeith
Re: OAK E stop - somehow setup for NO switch
You probably inverted INP11 using Ctrl-Alt-i on the Alt-i diagnostic screen.
Without a Report, though, that is just idle speculation.
Without a Report, though, that is just idle speculation.
-
- Posts: 8
- Joined: Wed Sep 05, 2018 9:40 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: 0925180673
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: OAK E stop - somehow setup for NO switch
Bingo that was it
Forgot all about that
On to the next
Thanks!!
Forgot all about that
On to the next
Thanks!!