Pneumatic Pump Lubrication Sysyem

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
carocad
Posts: 9
Joined: Fri Jun 11, 2021 2:17 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

Pneumatic Pump Lubrication Sysyem

Post by carocad »

Hello, I am wondering if anyone has a similar lubrication system and if you found a way to control it by the OAK PLC.
My is pneumatically actuated via a solenoid. I also have a low lube sensor (already connected to IN9), and another NC/NO sensor for cycle complete.
My problem is that this pump can only run 4 times/min. and I need at least 8 ON/OFF to complete a cycle.
Any help is much appreciated
Post Reply