when homing my bridge port I get a message on my screen z axis not homed 6,305 counts off. my encoder is tight, my belt is not moving, and my sheave is not moving. I was running last night no problem but tonight I start getting this warning in z now it came up in x. I reset part zero in z ran the program and it came up short
ANY IDEAS
x and z axis not homing
Moderator: cnckeith
-
littlerapids
- Posts: 5
- Joined: Tue May 20, 2014 10:41 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
-
diycncscott
Re: x and z axis not homing
The most likely cause is that the limit switch itself is sticking. Clean it up and your problem should go away.