I want to retrofit my mori seiki SL1A lathe, Yasnac control, it has a 12-tool hydraulic turret,
I want to install a board aok
I need help with the following:
Electrical diagram and PLC configuration for tool change.
The turret has 5 sensors, 1 for the locking position, and 4 for the position of the tools.
Mori Seiki SL1A
Moderator: cnckeith
-
wadyciprian
- Posts: 21
- Joined: Thu Apr 30, 2020 11:47 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: ACORN-375
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: No
-
Centroid_Tech2
- Posts: 97
- Joined: Mon Mar 03, 2014 4:24 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Mori Seiki SL1A
Centroid hasn't done one of those in awhile, but here is an older schematic to help you figure out the wiring for the sensors and contactors
along with a sample plc source code file to help with the logic.
along with a sample plc source code file to help with the logic.
- Attachments
-
- MORISD3B.pdf
- (957.93 KiB) Downloaded 41 times
-
- morisl3m.src
- (69.52 KiB) Downloaded 33 times
When requesting support READ THIS POST first. viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)