Intercon posting issue
Moderator: cnckeith
-
- Posts: 5
- Joined: Thu Apr 14, 2022 7:13 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Intercon posting issue
So I'm having an issue getting a program to post that I wrote in intercon it's a bunch of drilled holes and threadmill operations when I hit post it has a pop up that says a fatal error has been detected and it closes the software I have the .Icn file saved if anyone wants to look it over or has suggestions on what I need to look for to resolve this issue as always any help is greatly appreciated
Re: Intercon posting issue
Post a copy of the ICN file here, plus a current Report.
-
- Posts: 5
- Joined: Thu Apr 14, 2022 7:13 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Intercon posting issue
I'm pretty sure I found the problem there were a few threadmilling operations with 0s for the threads/inch I was assuming they were auto populating like the feeds and depths