Hello Everyone,
Wanted to make everyone aware we have updated TB294 for Notepad++ for the newer versions of Notepad++ software and with additional information compared to the previous version.
New version can be seen on our Tech bulletins page, but here is a direct link as well.
https://www.centroidcnc.com/dealersuppo ... ds/294.pdf
TB294 Configuring Notepad++ for use with the Centroid Controller has been updated.
Moderator: cnckeith
-
- Posts: 132
- Joined: Wed Jul 31, 2019 12:53 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
TB294 Configuring Notepad++ for use with the Centroid Controller has been updated.
When requesting support READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Centroid PLC Tutorial Videos
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Centroid PLC Tutorial Videos
-
- Posts: 32
- Joined: Wed Feb 19, 2020 11:49 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: 0818141095
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: TB294 Configuring Notepad++ for use with the Centroid Controller has been updated.
Hi Allin1Chris,
I use VSCode with an addin from marketplace "G-Code Language Support (Centroid)" by Daniel Berlin. IMHO it's a lot easier to install than the instructions for Notepad++. Configure VSCode to open any .nc file.
Check it out and let us know what you think.
I use VSCode with an addin from marketplace "G-Code Language Support (Centroid)" by Daniel Berlin. IMHO it's a lot easier to install than the instructions for Notepad++. Configure VSCode to open any .nc file.
Check it out and let us know what you think.
Lagunmatic 250
-
- Posts: 1967
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: TB294 Configuring Notepad++ for use with the Centroid Controller has been updated.
VSCode loads to slow for my taste compared to NP++
I see no benefits for CNC use compared to NP++
Uwe
I see no benefits for CNC use compared to NP++
Uwe