Just starting the retrofit, looking to learn about these Siemens drives and if they are good enough to keep or upgrade to Yaskawa and be done with it.
The machine ran where I bought it, and after the move the computer is way too finicky to put it to work. Wont boot, crash etc. I know the servos run fine although the do make quite a bit of noise sitting idle. Thoughts?
480V
Current Parts on hand
Oak Board
Three flying lead com cables
Nuc CNPC, pro
Wireless MPG
Out of stock and waiting
TT-4 toolset
KP-3 touch probe
Thermwood C40, Siemens 611U/E. Oak
Moderator: cnckeith
-
EastWood
- Posts: 3
- Joined: Wed Apr 06, 2022 9:39 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: A901118
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Thermwood C40, Siemens 611U/E. Oak
- Attachments
-
-
Last edited by EastWood on Wed Apr 06, 2022 11:53 am, edited 1 time in total.
-
EastWood
- Posts: 3
- Joined: Wed Apr 06, 2022 9:39 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: A901118
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Thermwood C40, Siemens 611U/E. Oak
I am no expert in this field, but I am willing to put the time and work in to figure it out. Looking for direction on where to find the info.
Is this enough info to figure the Pinout for the drives?
I have the Siemens book for series 6SN11.
Is this enough info to figure the Pinout for the drives?
I have the Siemens book for series 6SN11.