Hey folks,
I'd like to add to my Matsuura MC500 a rigid tapping and need to install a spindle encoder. Looking at it, there seems to be no place on the spindle I could do it (there is a pushing solenoid on the top of assembly). Is it possible to put it on the main motor and then recalculate it, or are there special encoders for that purpose?
Thanks, M
Spindle encoder
Moderator: cnckeith
-
- Posts: 91
- Joined: Thu Oct 17, 2013 4:32 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: 0605130770
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: Spindle encoder
The 'standard' solution when you can't get to the end of the shaft is to install a timing pulley on the shaft, and belt over to the encoder sideways.
Lloyd
Lloyd