Mill down: all in one, Lagun with Elrod conversion <fuse, user resolved>

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
parsonsj
Posts: 2
Joined: Wed May 27, 2020 9:53 am
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
CNC Control System Serial Number: 4108
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Mill down: all in one, Lagun with Elrod conversion <fuse, user resolved>

Post by parsonsj »

Hi All,

I upgraded to an All-in-One setup a couple of years ago. All has been fine since until today. When I power on, I don't hear the "pop" when the contactors close, and then I get a "Full power but no movement on Z-axis" error during initial homing.

I don't even know where to begin looking. Any help appreciated!
report_0403202391_2022-01-18_14-34-08.zip
(4.03 MiB) Downloaded 32 times
parsonsj
Posts: 2
Joined: Wed May 27, 2020 9:53 am
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
CNC Control System Serial Number: 4108
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Re: Mill down: all in one, Lagun with Elrod conversion

Post by parsonsj »

Never mind, just a fuse in the contactor circuit. Luckily I had a spare on hand.
Post Reply