Hi,
I am trying to gather information to start a Hardinge TFB project. I have received good information on ball screws and the installation. I am planning on using a Centroid allin1dc as I have experience with this board on my Bridgeport Boss machine.
The question is what size dc servo motor should be used on the z-axis and what size on the x-axis.
Hardinge TFB conversion to CNC
Moderator: cnckeith
-
- Posts: 231
- Joined: Mon Feb 07, 2011 8:03 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 1030090103
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: No
- Location: Montvale, NJ
Re: Hardinge TFB conversion to CNC
Can you measure the motors that are on the X and Y now and see if they are a standard NEMA mounting pattern? Maybe you can get a motor to fit in their place. Also, check to see if the current motors have gear heads built in or there is some other gearing in the motor drive train. I don't think they drive the existing leadscrews directly. Any existing gearing will have too much backlash, but you can probably get a good idea of what you can do to drive the leadscrews. Your gearing is going to matter. Personally, I would go with a 2:1 belt drive reduction and 12 to 15 in-lb servo. Those are good machines for a conversion because they don't come with threading, but many that I see are well worn as they were used in production often.
-
- Posts: 3094
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Hardinge TFB conversion to CNC
I'd go with a Centroid 10in/lb servo on X and a 16in/lb servo on Z.
Centroid DC Servo Motors with encoder and cable installed (middle of page)
Remember, this is a light-duty high-precision toolroom lathe. You not going to be hogging material with this machine so huge servos are not needed.
Space on X is also a consideration if you are going to fit everything on the carriage down into the existing chip tray. Not as big an issue if you intend to build up.
Centroid DC Servo Motors with encoder and cable installed (middle of page)
Remember, this is a light-duty high-precision toolroom lathe. You not going to be hogging material with this machine so huge servos are not needed.
Space on X is also a consideration if you are going to fit everything on the carriage down into the existing chip tray. Not as big an issue if you intend to build up.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.