KP-3 probe error 504 invalid parameter, line 98
Moderator: cnckeith
-
- Posts: 2
- Joined: Thu Dec 23, 2021 1:37 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: A901011
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
KP-3 probe error 504 invalid parameter, line 98
getting an error, when trying probe bore cycle. hit cycle start and get this error code. 2 axis cnc mill cnc12,m39 control system id 0008DC111213-0503211124 thank you.
- Attachments
-
- report_0008DC111213-0503211124_2021-12-23_11-58-59.zip
- (3.89 MiB) Downloaded 43 times
-
- Posts: 3094
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: KP-3 probe error 504 invalid parameter, line 98
You can't use automatic probing cycles with a 2-axis machine. You need Z controlled by CNC12 to automatic probe on most of the probe cycles. I don't know if you can use the x and then the y middle auto cycles without a z-axis. Give it a try and see if that is a work-around.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.