system test fail 511 line 1020 vfd
Moderator: cnckeith
-
- Posts: 2
- Joined: Thu Dec 23, 2021 1:37 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: A901011
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
system test fail 511 line 1020 vfd
first time posting here I have a 2 axis mill with a oak control, mpu12 system id 0008DC111213-0503211124 , when I run a system test I get alarm 511 line 1020, i did Verify that INP13 shows red in high, green in low range. If I manually control spindle in high or low range and Tach it it matches readout on the control. same if i turn spindle on MDI mode with s specific spindle speed and direction code. I have a automation direct GS23-25PO drive on a 4 hp spindle motor. I have attached a zip report and the VFD parameter setup list file from drive if that helps. Thank you.
- Attachments
-
- gs231223.xlsx
- (98.51 KiB) Downloaded 48 times
-
- report_0008DC111213-0503211124_2021-12-23_11-58-59.zip
- (3.89 MiB) Downloaded 57 times
-
- Posts: 3072
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: system test fail 511 line 1020 vfd
You can't run probing cycles on a two axis machine. You need a full 3-axis machine.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Re: system test fail 511 line 1020 vfd
Change your manual-axis labels (axes #3 and #4) to 'N' while you run the system test.