KP-3 probe for older probe replacement
Posted: Wed Nov 10, 2021 6:25 pm
Is the KP-3 the "replacement" for the previous versions of probes offered by Centroid?
We originally had a Dp4D early DSP version of the DP4, however the DSP ceased to work eventually and I disabled it in the control, using it as a standard kinematic probe.
The DP-4 has since died an ugly death and is resting In pieces due to a crash.
I have a cheapo probe that I use for rough setup, however I am looking to potentially begin some digitizing again and I do not like the cheapo for that.
Additionally does the KP-3 for legacy systems include the inverter circuit in the cable / connector so the tool touch probe can be used along with the KP-3 on the same input?
John
We originally had a Dp4D early DSP version of the DP4, however the DSP ceased to work eventually and I disabled it in the control, using it as a standard kinematic probe.
The DP-4 has since died an ugly death and is resting In pieces due to a crash.
I have a cheapo probe that I use for rough setup, however I am looking to potentially begin some digitizing again and I do not like the cheapo for that.
Additionally does the KP-3 for legacy systems include the inverter circuit in the cable / connector so the tool touch probe can be used along with the KP-3 on the same input?
John