The Identification plate says AJax CNC
Product: Control Console
Model: MILL
The workstation's power supply went bad and was replaced with new working unit. Now when the main switch is turned on, the touch screen LCD shows a black screen prompting for password. This appear to be a user password (not BIOS access password), as it's comes on as soon as the system powers on. Is there a default password used during deployment? Thx!
Power on Password prompt
Moderator: cnckeith
-
- Posts: 7325
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Power on Password prompt
post a photo.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
Re: Power on Password prompt
Try "159"
If all else fails, locate the motherboard jumper to clear the CMOS memory.
If all else fails, locate the motherboard jumper to clear the CMOS memory.