DELTA MS300 (Resolved)
Posted: Fri Sep 10, 2021 2:56 pm
Hello everybody,
I am currently working on the retrofit of a cnc with an Allin1Dc. My predecessor had bought a chinese atc spindle with a vfd delta ms300.
Spindle :
On allin1dc the motor is set with a speed range of 12000 to 24000.
But unfortunately it does not work, the vfd displays an error message
I may have forgotten the settings?
Has anyone ever had a problem with the Delta MS300?
Is it plugged into the allin1dc?
Thanks in advance
Max
I am currently working on the retrofit of a cnc with an Allin1Dc. My predecessor had bought a chinese atc spindle with a vfd delta ms300.
Spindle :
- 380 V
10A
5.5Kw
400-800Hz
12000-24000Rpm
- Delta MS300
INP/OUT 3Ph 380-480V
- AVI (0-10V) - DAC OUT
ACM - DAC COM
MI1 - OUT 8 NC (CW)
MI2 - OUT 8 NO (CCW)
DCM - OUT 5 COM / OUT 7 COM
- 00-03 - 1 - Start Up Display Selection -- 1 out put frequency
00-21 - 2 - Source of the operation command -- 2 External terminals
01-00 - 599 - Max operation frequency of motor 1 -- 0 to 599.00hz
01-01 - 599 - Output frequency of motor 1 -- 0 to 599.00hz
01-02 - 380 - Output voltage of motor 1 -- 0 to 480V
05-01 - 10 - Full load current of induction motor 1 (A)
05-02 - 5.5 - Rated power of induction motor 1 (Kw) - 0-655.35Kw
On allin1dc the motor is set with a speed range of 12000 to 24000.
But unfortunately it does not work, the vfd displays an error message
- "ou5" --> Hardware failure in
voltage detection --> Check if input voltage is within specification
range and monitor if there is surge voltage.
I may have forgotten the settings?
Has anyone ever had a problem with the Delta MS300?
Is it plugged into the allin1dc?
Thanks in advance
Max