Oak H1 Power Connector
Posted: Wed Jun 09, 2021 5:05 pm
I am in the process of putting all of my CNC components in an enclosure. In the enclosure I have 3 separate ABB power supplies 5V, 12V, and 24V. What I would like to do is connect the oak board to these power supplies and no longer use the mean-well. However upon disconnecting it I quickly grew confused on how to make some of the connections. I have listed the pins below. Each power supply has a + and - terminal. What I think I understand is from the H1 connector pin 1 goes to 12v power supply +, pin 2 ????, pin 3 12 power supply-, pin 4 5V power supply+, pin 5 ???? Possibly 5V power supply -, pin 6 goes to earth ground, please let me know what you guys think. Any advice will be greatly appreciated.
Pin 1: +V2(12V)
Pin 2: COM (12V COM)
Pin 3: -V4 (-12V)
Pin 4: +5V
Pin 5: COM (5V)
Pin 6: ACG (AC GROUND)
Thank you
Robbie
Pin 1: +V2(12V)
Pin 2: COM (12V COM)
Pin 3: -V4 (-12V)
Pin 4: +5V
Pin 5: COM (5V)
Pin 6: ACG (AC GROUND)
Thank you
Robbie