I am in the process of putting all of my CNC components in an enclosure. In the enclosure I have 3 separate ABB power supplies 5V, 12V, and 24V. What I would like to do is connect the oak board to these power supplies and no longer use the mean-well. However upon disconnecting it I quickly grew confused on how to make some of the connections. I have listed the pins below. Each power supply has a + and - terminal. What I think I understand is from the H1 connector pin 1 goes to 12v power supply +, pin 2 ????, pin 3 12 power supply-, pin 4 5V power supply+, pin 5 ???? Possibly 5V power supply -, pin 6 goes to earth ground, please let me know what you guys think. Any advice will be greatly appreciated.
Pin 1: +V2(12V)
Pin 2: COM (12V COM)
Pin 3: -V4 (-12V)
Pin 4: +5V
Pin 5: COM (5V)
Pin 6: ACG (AC GROUND)
Thank you
Robbie
Oak H1 Power Connector
Moderator: cnckeith
-
- Posts: 3095
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Oak H1 Power Connector
I suggest just keeping the Meanwell supply. It helps separate the controller from EMI and noise generated from other devices connected to your supplies. If you really want to replace the Meanwell, you'll need to add a -12V supply to your system.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
-
- Posts: 15
- Joined: Sat Sep 12, 2020 11:18 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: 0617200971
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Oak H1 Power Connector
Tblough,
Thank you for the advice, I will reconnect the mean-well power supply.
Robbie
Thank you for the advice, I will reconnect the mean-well power supply.
Robbie
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Oak H1 Power Connector
Don't use the Meanwell Logic power supply for anything else. Follow the schematic.
Contactors would use a separate power supply, solenoids etc.
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ