Issue running PID TUNE

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
repauli1
Posts: 24
Joined: Thu Jul 09, 2020 9:50 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

Issue running PID TUNE

Post by repauli1 »

Serial# A900863 Centroid OAK
When I goto PID, TUNE, it pops up the box to instruct you to "cycle start", when I do so it give me the message "error: status #6"
any ideas?
Attached log file
Attachments
report_0610200966_2021-04-20_12-26-25.zip
(217.22 KiB) Downloaded 5 times
cncsnw
Posts: 2039
Joined: Wed Mar 24, 2010 5:48 pm

Re: Issue running PID TUNE

Post by cncsnw »

I think you are getting a little ahead of yourself.

You want to have your hardware configured (e.g. decide what axes you have, and what PLC expansion boards you have, etc.); and have your software configured (e.g. decide what axes you have, verify that you have correct encoder counts entered, etc.); and be able to slow-jog all of your axes under control; and preferably have your directions and turns ratios and travel limits set up, before you should even care about the delay-time autotune.
Post Reply