Disable homing for testing
Moderator: cnckeith
-
- Posts: 160
- Joined: Thu Jul 09, 2020 9:50 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Disable homing for testing
How can I disable the homing after start up so I can commission the drives center of their axis?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Posts: 117
- Joined: Fri Jun 10, 2011 8:31 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Disable homing for testing
Set P05=1
Then restart
Aamir
Then restart
Aamir
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Posts: 160
- Joined: Thu Jul 09, 2020 9:50 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Disable homing for testing
Thanks, that did the job!
(Note: Liking will "up vote" a post in the search results helping others find good information faster)