Manual tuning of DMM, HOME NOT SET
Moderator: cnckeith
-
- Posts: 156
- Joined: Thu Jul 09, 2020 9:50 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Manual tuning of DMM, HOME NOT SET
How can I bypass home not set while commissioning drives?
Re: Manual tuning of DMM, HOME NOT SET
Just run "M26/X/Y/Z" from the MDI prompt, to set home wherever it sits.
Presumably you do not have software travel limits entered yet. If you do, you will want to jog it close to the home position before you set home that way.
Presumably you do not have software travel limits entered yet. If you do, you will want to jog it close to the home position before you set home that way.