Hi there
I posted at April 24 2011 as below:
"I have in my mill the below:
CPU7
PLC windc3io
CPU PIC:IO2PIC(PLC I02)
CNC 10 Mill v1.21
Can I update the CNC10 Mill v1.21 to the latest version?
Thank you"
Answer was:
--->by cncsnw » Mon Apr 25, 2011 5:22 am
"You can update to CNC10 v2.38.
If you have at least 512MB memory in your computer, then you can update to CNC10 v2.70."
But until now, I can't find anything about these updates.
Can anyone help me?
Thank you
CNC10 Mill update
Moderator: cnckeith
-
- Posts: 431
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: CNC10 Mill update
Please take a look at the Legacy Software Page for full instructions. Also note the new computer hardware requirements for CNC10 2.72, your PC may need to be upgraded as well. There were also some changes in the way unlocks were handled after 2.70 , please take a look at TB243: Restoring Configuration and Unlocks From a Report onto CNC10 v2.70+. It also includes details on parameters that should be changed from your old configuration.
Alternatively we can send you a new Flash Card, Flash Card Reader, Flash Card Cable, with CNC10 2.72 installed for $425. If you send us a report of your system we can load all of your parameters and settings on the new flash card so all you have to do is hook it up and your ready to go.
Alternatively we can send you a new Flash Card, Flash Card Reader, Flash Card Cable, with CNC10 2.72 installed for $425. If you send us a report of your system we can load all of your parameters and settings on the new flash card so all you have to do is hook it up and your ready to go.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)