Strange problem
Moderator: cnckeith
-
- Posts: 4
- Joined: Mon Mar 05, 2012 3:47 pm
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: 313120402
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Strange problem
Having unusual probrem which started yesterday, after loading Vectric 2d cut, mill does not comunicate with computer, found that when Allin1dc is booting up bvut gives LED error code 1, which says something is wrong with power supply, checked all voltages, voltages were 3.31,12.1,-11,87,5.03 which all seem to be ok, An 12 and -12 led lit up,all LEDs on board lit up except DF and DBUG is blinking. It seems everything is working ok power supply ways. Any sugestions.
-
- Posts: 431
- Joined: Mon Jul 18, 2011 9:57 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Strange problem
Problem resolved by re-installing Windows 7. Somehow the IP Stack in Windows became corrupted. A solid 1 on the LED means the ALLIN1DC is functioning properly.
When requesting support READ THIS POST first. https://www.viewtopic.php?f=60&t=1043
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.
(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)