How do you post a report from the All In One
Moderator: cnckeith
-
- Posts: 77
- Joined: Sat Oct 19, 2019 3:53 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: A900779
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Hoboken, NJ
- Contact:
How do you post a report from the All In One
I'm asking this dumb question since the last time it was a total disaster. I now have internet on the unit computer. Thanks, Bob L
Bridgeport V2XT, All In One DC #A900779. Using existing SEM motors 112 Volt. Spindle to be controlled by Lenze AC Tech VFD mod #ESV222N02YXB. Machine is being run on 208 3Phase power.
Re: How do you post a report from the All In One
F7/Utility
F7/Report
Arrow down to highlight "[reportbackup]"
F10/Accept
Now you have a new report....zip file saved in the c:\cncm\reportbackup folder on your control's computer. There are probably multiple older report files in that same folder as well.
Start a post or reply on this forum. Click on "Full Editor & Preview".
Below the box you are typing your text in, look for a tab called "Attachments". Click on it.
Click on "Add files"
Browse to the c: drive, cncm directory, reportbackup subdirectory.
Look for the ZIP file that has the newest date (which should be today's).
Click on that file to highlight it, then click on the "Open" button.
Click "Submit" to post your message, with the attached file.
F7/Report
Arrow down to highlight "[reportbackup]"
F10/Accept
Now you have a new report....zip file saved in the c:\cncm\reportbackup folder on your control's computer. There are probably multiple older report files in that same folder as well.
Start a post or reply on this forum. Click on "Full Editor & Preview".
Below the box you are typing your text in, look for a tab called "Attachments". Click on it.
Click on "Add files"
Browse to the c: drive, cncm directory, reportbackup subdirectory.
Look for the ZIP file that has the newest date (which should be today's).
Click on that file to highlight it, then click on the "Open" button.
Click "Submit" to post your message, with the attached file.