Page 1 of 1
Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder
Posted: Fri Feb 19, 2021 3:11 pm
by manni
Hi,
Any advise on this type of encoder - Renco ENCODER RS25D-1000-3/8-5-LD0M1
I have look online but unable to find any info on this type of encoder.
Please check attached image of encoder.
Thanks
Regards
Manni
Re: Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder
Posted: Fri Feb 19, 2021 5:08 pm
by tblough
Just a quick guess that it's a 1000 line 5V line driver encoder with a 3/8" shaft. You'd have to check the Renco website to be sure.
Re: Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder
Posted: Fri Feb 19, 2021 6:32 pm
by cncsnw
If the MS connector is a 10-pin 18-1 pattern, then there is a reasonable chance that it is a differential encoder, and uses the same pin-out as a US Digital HD25 or Koyo TRDA-25 model.
See
https://cdn.usdigital.com/assets/datash ... 7600845398
and
https://cdn.automationdirect.com/static ... series.pdf
Re: Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder
Posted: Tue Feb 23, 2021 9:36 am
by manni
Thank you tblough & cncsnw,
The TRDA-25 model was the perfect match.