Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
manni
Posts: 15
Joined: Sun Jan 24, 2021 2:58 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none
Location: Walsall - UK
Contact:

Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder

Post by manni »

Hi,

Any advise on this type of encoder - Renco ENCODER RS25D-1000-3/8-5-LD0M1

I have look online but unable to find any info on this type of encoder.

Please check attached image of encoder.
Thanks

Regards
Manni
Attachments
IMG-20210219-WA0009.jpg
tblough
Posts: 1343
Joined: Tue Mar 22, 2016 10:03 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192
Location: Boston, MA
Contact:

Re: Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder

Post by tblough »

Just a quick guess that it's a 1000 line 5V line driver encoder with a 3/8" shaft. You'd have to check the Renco website to be sure.
Cheers,

Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
cncsnw
Posts: 1892
Joined: Wed Mar 24, 2010 5:48 pm

Re: Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder

Post by cncsnw »

If the MS connector is a 10-pin 18-1 pattern, then there is a reasonable chance that it is a differential encoder, and uses the same pin-out as a US Digital HD25 or Koyo TRDA-25 model.
See https://cdn.usdigital.com/assets/datash ... 7600845398
and https://cdn.automationdirect.com/static ... series.pdf
manni
Posts: 15
Joined: Sun Jan 24, 2021 2:58 pm
Acorn CNC Controller: No
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none
Location: Walsall - UK
Contact:

Re: Haas VF-1 1994 Retrofit to Centroid Allin1DC - Spindle Encoder

Post by manni »

Thank you tblough & cncsnw,

The TRDA-25 model was the perfect match.
Post Reply