Centroid Community CNC Support Forum

I know this servo has echo generators but I have the ability to change them to an encoder if needed. Will the all in one support it. Sorry Pic is upside down for some reason it shows right side up when I download but shows up this way.

Thanks

With a continuous stall torque of ca. 124 in-lb, and continuous stall current of 17A, that looks a little big for the Allin1DC.

If you could run it, you would have to run it at reduced voltage and speed, as the Allin1DC cannot tolerate 183VDC.

Moved this topic to the All in One DC/OAK/Legacy forum from the Acorn Forum