I know this servo has echo generators but I have the ability to change them to an encoder if needed. Will the all in one support it. Sorry Pic is upside down for some reason it shows right side up when I download but shows up this way.
Thanks
Will All in one Board support this servo
Moderator: cnckeith
Re: Will All in one Board support this servo
With a continuous stall torque of ca. 124 in-lb, and continuous stall current of 17A, that looks a little big for the Allin1DC.
If you could run it, you would have to run it at reduced voltage and speed, as the Allin1DC cannot tolerate 183VDC.
If you could run it, you would have to run it at reduced voltage and speed, as the Allin1DC cannot tolerate 183VDC.
-
- Posts: 9912
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Will All in one Board support this servo
Moved this topic to the All in One DC/OAK/Legacy forum from the Acorn Forum
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ