Will All in one Board support this servo

All things related to Centroid Oak, Allin1DC, MPU11 and Legacy products

Moderator: cnckeith

Post Reply
balbino
Posts: 6
Joined: Sun Nov 15, 2020 11:14 am
Acorn CNC Controller: No
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: none

Will All in one Board support this servo

Post by balbino »

I know this servo has echo generators but I have the ability to change them to an encoder if needed. Will the all in one support it. Sorry Pic is upside down for some reason it shows right side up when I download but shows up this way.

Thanks
servo.jpg
cncsnw
Posts: 1873
Joined: Wed Mar 24, 2010 5:48 pm

Re: Will All in one Board support this servo

Post by cncsnw »

With a continuous stall torque of ca. 124 in-lb, and continuous stall current of 17A, that looks a little big for the Allin1DC.

If you could run it, you would have to run it at reduced voltage and speed, as the Allin1DC cannot tolerate 183VDC.
martyscncgarage
Posts: 7489
Joined: Tue Mar 28, 2017 12:01 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC12: Yes
CNC11: Yes
CPU10 or CPU7: Yes
CNC Control System Serial Number: none
Location: Mesa, AZ

Re: Will All in one Board support this servo

Post by martyscncgarage »

Moved this topic to the All in One DC/OAK/Legacy forum from the Acorn Forum
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
Post Reply